The third mode "Standard" is a compromise between the largest possible number of channels and security. If more channels are needed and the environmental conditions are good, the setup can be calculated with "More Frequencies". However, the maximum number of channels can not be used here. There are three different security levels: If "Robust" is selected, the calculation of the individual frequencies will ensure that the setup works reliably even under difficult conditions.
#Tg pro systems software
All beyerdynamic wireless microphones with their associated frequency parameters are stored in the software and can be used directly. The Frequency Calculation section can be used to calculate frequency setups, especially for multi-channel applications. With "Load" previously saved scans can be recalled. The scan can be saved as image and excel file for later calculation. When a scan is finished, the result can be saved via "Save". The scan can be stopped at any time by clicking the "Stop" button. Clicking the Continious Scan button permanently scans the selected area. Click on the "Single Scan" button to perform a one-time scan. Before a scan is started, the frequency range and the resolution can be specified. Since the scan must rely on a receiver channel, only channels can be selected after which the frequency scan is called, on which no transmitter is active. The TG Wireless Manager offers this option under the "Frequency Scan" section. In preparation for an event, the frequency range should be scanned to detect possible interference, such as DVB-T. Once the test is completed, the result can be saved as an image file. After starting the test, the RF levels of both antennas are displayed so that it is immediately apparent where there is no good coverage. By clicking on the "Walking Test" button, a new window opens in which the channel to be tested can be selected. Under "Walking Test", the RF coverage can be e.g. By clicking on the button "Go Offline" the project can be put offline again. As an additional Add On, a channel can be switched off via the "Channel Mute" button without having to set it directly on the transmitter. As soon as resynchronization is required, the "sync symbol" appears on the interface. In addition, all other settings, such as "Power Lock" displayed. The gain can be changed via the buttons "+" and "-" directly in the channel display without opening the settings. Likewise, the RF level and the audio level are displayed as bars. As soon as a transmitter on the channel is switched on, the surface of the channels in the software indicates the used handheld transmitter with capsule or bodypack transmitter.
The project will then be automatically set online. With the "Quick Start" button all channels of the recipients that are in the network can be displayed on the desktop. Now the query opens, if the settings should be taken over from the project or from the receivers.
#Tg pro systems Pc
Issue where on some M1 Pro/Max/Ultra and M2 models the GPU temperature would incorrectly show 5℃ or 104℃.If the receivers and the PC / notebook are in a network, the project can be switched online via "Go Online" after preparing a project in offline mode.
#Tg pro systems install
#Tg pro systems full
Added full support for the MacBook Air (M2, 2022).TG Pro supports all Macs, including all MacBook Pros (including 2015 models), iMacs, Mac Minis, MacBook Airs, and Mac Pros (including newer 2013 model). See why thousands of people trust TG Pro as the go-to app for temperatures and fan control. Plus, see if any sensors or fans are defective with the built-in hardware diagnostics. Find out which components are getting hot (and potentially overheating), turn up the fan speeds to cool down your Mac, get notifications for temperature alerts along with many other fantastic features. No other app shows more temperature sensors or has as many options for notifications and fan speeds. TG Pro will give you a look at what’s going on inside your Mac.
0 kommentar(er)
